Bakers Pride Oven FW-15 Manuel d'utilisateur Page 13

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 36
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 12
Fry Warmer Maintenance
11
Troubleshooting
Refer to the table below for troubleshooting information.
Problem Cause Possible Solution
Warmer chute is not
holding heat
Ceramic heating
element failure
Contact an authorized BKI service agent for
corrective action.
Noisy fan
Fan blade is dirty or fan
bearings are failing
Contact an authorized BKI service agent for
corrective action.
FW-15/FW-15T/FW-15DTO (Bottom Breather)
Warmer chute is not
heating and perforated pan
is not heating
No power to unit. Make sure that the circuit breaker and switch at the
power supply are supplying power to the unit. If
problem persists, contact licensed electrician.
Warmer chute is heating
and the perforated pan is
not heating
Fan has overheated and
cut off
Or
Heating coil has failed
Wipe the dust from the air intake louvers to allow
proper airflow and prevent fan overheating. Turn
the power switch off. Wait 60 seconds. Turn the
power switch back on.
Contact an authorized BKI service agent for
corrective action.
FW-12/FW-12T/FW-15 (Side Breather)
Warmer chute is not
heating and perforated pan
is not heating
No power to unit or main
switch is off.
Make sure that the circuit breaker and switch at the
power supply are supplying power to the unit. If
problem persists, contact licensed electrician.
Warmer chute is heating
and the perforated pan is
not heating
Fan has overheated and
cut off or fan has failed
Or
Heating coil has failed
Check to see if dust or any other object is blocking
the air intake. Remove blockage if necessary. If
problem persists contact an authorized BKI service
agent for corrective action.
Contact an authorized BKI service agent for
corrective action.
Repair
Before replacing any parts, make sure the power has been turned off and the unit has
cooled down.
Lamp Replacement
Only use Teflon-coated lamp to prevent glass contamination.
1. Make sure power to the unit is OFF and the unit has cooled down.
2. Carefully remove the faulty lamp.
3. Replace with the new lamp.
Vue de la page 12
1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 35 36

Commentaires sur ces manuels

Pas de commentaire